AX 1030 ADC – vBlade thread stopped

Community Forum Forums Thunder and AX Series General AX 1030 ADC – vBlade thread stopped

Tagged: ,

This topic contains 1 reply, has 2 voices, and was last updated by avatar dshin 1 year, 6 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #13072
    avatar
    ins007
    Member

    Got few warnings popup, what does these means? Significant?

    Warning [VCS] vBlade thread stopped
    Warning [VCS] vBlade thread: peer gone, reconnect (0)
    Warning [VCS] something wrong with the connection, try to reconnect
    Warning [VCS] vMaster(device 2) is gone:lack of heartbeats

    Warning [VCS] vBlade daemon SIGALRM is not blocked

    Warning [ACOS] HA Gateway check failed for 10.x.x.x

    Error [VCS] Device specific configuration <Module: 41217 Type: 7
    Sub-type: 558> failed to execute on device <1>: Communication error with LB process

    Warning [VCS] vBlade thread stopped
    Warning [VCS] vBlade lose connect with vMaster
    Warning [VCS] vBlade thread: peer gone, reconnect (0)
    Warning [VCS] something wrong with the connection, try to reconnect

    Warning [ACOS] The total IP multicast packets 59015 per second has exceeded
    the configured all VLAN limit of 5000

    #13122
    avatar
    dshin
    Member

    Ins007,

    Please initiate a “show core” command to validate if the device is still in service and this command should identify where the crashed had occured. It looks like the vblade device maybe in the process of crashing so thats the cause of the system to stop the connection to vMaster. And later message states “Communication error with LB process” means vBlade already crashed.

    Genard

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Comments are closed.