Real server through a default GW

Community Forum Forums Thunder and AX Series Real server through a default GW

This topic contains 0 replies, has 1 voice, and was last updated by avatar Hugo Gomez 8 months, 1 week ago.

Viewing 1 post (of 1 total)
  • Author
  • #16122
    Hugo Gomez

    Hi community
    I’m new in a10 knowledge and I want to ask your help with a doubt

    I can’t reach a real server, when I apply a test and a debug I can see that no traffic is sending to that server IP.
    That server is not in the same LAN segment I can ping that server and reach it through my default gw that is a Checkpoint FW

    I see the FW IP in my arp table
    I not see the IP of the server because is not in my arp table, I only can reach that server IP through de FW (My def gw)

    This is my configuration for that service:

    vlan 313
    untagged ethernet 3
    router-interface ve 313
    vlan-global enable-def-vlan-l2-forwarding
    hostname MITMTY-A10-01
    interface ethernet 3
    interface ve 313
    ip address
    ip nat pool SNAT_172_16_10_0 netmask /24
    ip route /0
    slb server WAF_SRV_MITEC >>>>as you can see the server is in other segment
    port 40020 tcp
    slb service-group WAF_EPAGO tcp
    member WAF_SRV_MITEC 40020
    slb virtual-server ADC_WAF_E-PAGO
    port 80 http
    source-nat pool SNAT_172_16_10_0
    source-nat auto
    service-group WAF_EPAGO

    Can you tell me if there is something lacking in my configuration
    The trace rach the server through the FW
    I send a Telnet to the server IP in the 40020 port and the connection is successful

    Your help will be great for me


Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

Comments are closed.